Page 2
INTRODUCTION Thank you for purchasing the SLSUPB10 - SLSUPB20. Please read this manual carefully before using this product www.PyleUSA.com...
Page 3
WHAT’S WHAT? Carrying Handle Tie down Bungee Cords Air Valve Leash Plug SLSUPST15 Sup Seat *sold separately Fins www.PyleUSA.com...
Page 4
GETTING STARTED CONTENTS • Paddle-Board • Coiled Ankle Cuff Safety Leash • Oar Paddle • Manual Air Pump • Patch Repair Accessory Kit • Storage / Carry Bag INFLATING THE SUP BOARD 1. Roll out the SUP board until it is laying flat with top side facing up. 2.
GETTING STARTED SUP BOARD MR PUMP Your SUP Board comes with a high pressure pump. This pressure pump, pumps low volume of air with each pumping motion. It takes longer to fill the board with air, but allows the board to reach a higher air pressure. This is good for achieving maximum performance from the board.
GETTING STARTED REPAIR KIT If your board needs repair, use the patches in the repair kit and follow these steps: 1. Deflate the board completely, lay it flat and wait for it to dry. 2. Cut a patch that is 2 inches larger than the tear/rip all the way around. 3.
Page 7
APPENDIX FOR YOUR SAFETY • Check your board and equipment before going in the water. • Try to avoid going on the water alone. • Always have a mode of communicating while on the water. • Check weather conditions and tide before going out to ride. •...