Specifications - Toro Reelmaster 3550-D Preliminary Service Manual

Specifications

Frame Construction: Precision machined die cast alu-
minum cross member with two (2) bolt--on cast alumin-
um side plates.
Reel Construction: Reels are 18 inches (45.7 cm) in
length and 5 inch (12.7 cm) in diameter. High strength,
low alloy steel blades are thru hardened and impact re-
sistant. Reels are available in 8 and 11 blade configura-
tions. Optional 22 inch (55.9 cm), 8 blade reels are
available for the rear cutting unit positions.
Reel Bearings: Two sealed, stainless steel ball bear-
ings support the reel shaft.
Reel Drive: The reel weldment shaft is a 1 5/16 inch
(33.3 mm) diameter tube with drive inserts threaded into
both ends. The reel drive inserts have an internal eight
(8) tooth spline.
Height- -of- -Cut (HOC): Cutting height is adjusted on
the front roller by two (2) vertical screws. Effective HOC
may vary depending on turf conditions, type of bedknife,
roller type and installed attachments.
DPA Cutting Units
Figure 1
Bedknife: Replaceable, single edged, EdgeMax
bedknife is fastened to a machined cast iron bedbar with
screws. Optional bedknifes are available.
Bedknife Adjustment: Dual screw adjustment to the
reel; detents corresponding to 0.0007 inch (0.018 mm)
bedknife movement for each indexed position.
Front and Rear Rollers: Greaseable through--shaft
front and rear rollers are used with these cutting units.
Both rollers use the same heavy duty ball bearings.
Counterbalance Weight: A cast iron weight mounted
opposite to the hydraulic drive motor balances the cut-
ting unit.
Cutting Unit Weight:
18" Reel, 8 Blade
18" Reel, 11 Blade
22" Reel, 8 Blade (optional) 94 lb. (43 kg)
Options:
Refer to Cutting Unit Operator's Manual for available op-
tions for your Reelmaster DPA cutting unit.
Page 7 - - 2
TM
86 lb. (39 kg)
88 lb. (40 kg)
Reelmaster 3550--D