Clearing Fault Codes
After fault codes have been retrieved, clearing of those
faults can be completed using the following switch se-
quence:
1. Place machine switches in fault retrieval (see Re-
trieving Fault Codes above). The diagnostic light should
be displaying the fault codes.
Reelmaster 3550--D
2. Operator seat should remain UNOCCUPIED.
3. Move mow/backlap lever on the hydraulic mow con-
trol manifold to the BACKLAP position.
4. Move joystick to the RAISE position.
5. Monitor the diagnostic light for continuous flashing
indicating that all faults have been cleared from the con-
troller memory.
Page 5 - - 9
Electrical System