Setup; Lamp - Chauvet TFX-64CM User Manual

S
ETUP

Lamp

You will need to install a lamp prior to the initial operation of the fixture. Either three GLC or GKV
575W halogen lamps are included.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
LA M P IN STA LLA T ION AND R EPLAC EMENT
1) Loosen the thumbscrews as illustrated in figure
1 (3 total) located near the front of the fixture.
2) Pull the lens assembly out from the fixture as
illustrated in figure 2.
3) Hold the bi-pin lamps with a napkin and pull
top end of lamp upwards to remove from
socket as illustrated in figure 3.
4) Hold the new lamp with a lint-free cloth, and
insert lamp downward into the socket as
illustrated in figure 3.
Note:
5) Replace lens cover housing and tighten
thumbscrews.
6) No lamp alignment is necessary for this fixture.
TFX-64CM User Manual
Lens cover can only be inserted one
way! Match up the labels on the lens
cover and the fixture to reinsert the
lens cover properly.
TFX-64CM Lamp Installation
1
2
Note: Align labels on lens
cover and fixture to
reinsert.
3
6
Revision: 2006-11-30/17:23