Setup; Ac Power; Mounting - Chauvet ST-800X User Manual

Strobe lights
Hide thumbs Also See for ST-800X:
Table of Contents

Advertisement

3. Setup

AC Power

Warning!
Verify that the power requirement label on your unit matches the line voltage
applied. All fixtures must be connected to circuits with a suitable Earth Ground.
• To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture's specifications chart.
• A fixture's listed current rating is its average current draw under normal conditions.
• All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
• Before applying power to a fixture, check that the source voltage matches the fixture's
requirement.
• All fixtures must be connected to circuits with a suitable Earth Ground.
P ow e r C a b l e C o n f i g u r a t i o n
C
ABLE
B
ROWN
B
Y
ELLOW

Mounting

O r i e n t a t i o n
This fixture can be mounted on a truss using a clamp in any position or against a flat surface using
the brackets provided.
R i g g i n g
The fixture includes a mounting yoke to which 1 rigging clamp can
be bolted. You must supply your own clamp and make sure the
clamp is capable of supporting the weight of this fixture. You can
order C-clamps from any CHAUVET dealer or distributor.
1.
2.
3.
4.
5.
ST-800X User Manual
Pin
International
Live
Neutral
LUE
/G
Earth
EG (Ground)
REEN
Block access below the work area and use suitable and stable
platform when installing or servicing fixture.
Align the clamp screw with the center hole on the yoke and tighten.
Verify the structure can hold 10 times the weight of all to-be installed fixtures.
Adjust the angle on the yoke arm as necessary.
Always use a safety cable or chain as a secondary source of attachment. The safety cable must hold 10
times the weight of the fixture. If safety cable attachment point is provided that is permanently affixed to
the surface or body of the fixture, use that instead of looping through a hanging yoke/arm.
Screw Color
L
Yellow or Brass
N
Silver
Green
7
Hanging Clamp
2007-03-07
10:58
/

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dmx mega strobe ii

Table of Contents