Igeneral Safety Rules; Introduction; Guards; Safety Signs To Be Placed On The Machine Or Near Its Area - Electrolux EHT8 Installation And Operating Manual

NOTE!
For electrical connections, see the wiring diagram.
I GENERAL SAFETY RULES
I.1

Introduction

The machines are provided with electric and/or mechanical
safety devices for protecting workers and the machine itself.
Therefore the user must not remove or tamper with such
devices.
The Manufacturer declines any liability for damage due to
tampering or their non-use.
I.2

Guards

The guards on the machine are:
• fixed guards (e.g. casings, covers, side panels, etc.), fixed
to the machine and/or frame with screws or quick-release
connectors that can only be removed or opened with tools;
• interlocked movable guards (door) for access inside the
machine;
• machine electrical equipment access doors, made from
hinged panels openable with tools. The door must not be
opened when the machine is connected to the power supply.
WARNING
Several illustrations
manual show the machine, or
parts of it, without guards or with
guards removed. This is purely
for explanatory purposes. Do not
use the machine without the
guards or with the protection
devices deactivated.
I.3 Safety signs to be placed on the machine or
near its area
Prohibition Meaning
do not oil, lubricate, repair and adjust
moving parts
do not remove the safety devices
do not use water to extinguish fires
(placed on electrical parts)
Danger
in the
I.4

Instructions for use and maintenance

Risks mainly of a mechanical, thermal and electrical nature
exist in the machine. Where possible the risks have been
neutralised:
• directly, by means of adequate design solutions.
• indirectly by using guards, protection and safety devices.
Any anomalous situations are signalled on the control panel
display.
During maintenance several risks remain, as these could not
be eliminated, and must be neutralised by adopting specific
measures and precautions.
Do not carry out any checking, cleaning, repair or maintenance
operations on moving parts. Workers must be informed of this
prohibition by means of clearly visible signs.
To guarantee machine efficiency and correct operation,
periodical maintenance must be carried out according to the
instructions given in this manual.
Make sure to periodically check correct operation of all the
safety devices and the insulation of electrical cables, which
must be replaced if damaged.
CAUTION
If changing to a different detergent/rinse-
aid type (even one by the same manufac-
turer), you must rinse the suction and
pressure hoses with fresh water before
connecting the new detergent/rinse-aid
container. Otherwise, the mixing of differ-
ent types of detergent/rinse-aid will cause
crystallisation, which may result in a
breakdown of the dosing pump. Failure to
observe this condition will invalidate the
guarantee and product liability.
Meaning
danger of crushing hands
caution hot surface
danger of electrocution (shown on elec-
trical parts with indication of voltage)
WARNING
Do not remove, tamper with or
make illegible the safety, danger
and instruction signs and labels
on the machine.
29