3-Pin To 5-Pin Conversion Chart; Setting Up A Dmx Serial Data Link - Chauvet Batten 80i User Manual

3 -PIN TO 5-PIN CONVERSION CHART
Note!
3 P
IN TO
Con duc
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Do not use
Do not use

Setting up a DMX Serial Data Link

1. Connect the (male) 3 pin connector side of
the DMX cable to the output (female) 3 pin
connector of the controller.
2. Connect the end of the cable coming from
the controller which will have
pin connector to the input connector of the
next fixture consisting of a (male) 3 pin
connector.
3. Then, proceed to connect from the outpu
as stated ab
fixture and so on.
CHAUVET Certified DMX Data Cables
Order Code
DMX1.5
DMX4.5
DMX10
COLORado™ Batten 80i User Manual
If you use a controller with a 5 pin DM
adapter. CHAUVET Model No: DMX5M, or DMX5F.
The chart below details a proper cable conversion:
5 P C C
IN ONVERSION HART
tor 3 Pin Female (output)
Pin 1
Pin 2
Pin 3
a (female) 3
ove to the input of the following
D escription
DMX Cable 1.5m/4.9ft
DMX Cable 4 .5m/14.8ft
DMX Cable 10m/32.8ft
X output connector, you will need to use a 5 pin to 3 pin
5 Pin Male (Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use
U niversal DM X Controller
t
Continue the link
13
This drawing provides a
general illustration of the
DMX Input/Output panel of
a lighting fixture.
5/19/2008 10:40 AM