Table of Contents
Advertisement
S
ETUP
Lamp
You may need to install a lamp prior to the initial operation of the fixture. An EHJ 250W halogen lamp
is included. This lamp is used for both the 115V and 230V settings.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to
cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L AM P I N ST ALL AT I O N
1)
Remove the two (S1) screws located in front
of the fixture as shown in the image.
2)
Pull the lamp plate out exposing the lamp
and socket. (not shown)
3)
If replacing the lamp, remove old lamp first.
4)
Using a cloth or napkin hold the bulb and
pull out of the lamp socket located inside the
reflector.
5)
Replace with a new lamp.
6)
Replace lamp plate, align the screw holes
and fasten the screws.
Mounting
O RI E NT AT IO N
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIG G ING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable "C" or "O"
type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding
the desired position, retighten both knobs.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables should always be used.
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
Fuse Replacement
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a flat head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.
CH-244 User Manual
S1
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
5
Lamp plate
Hanging Clamp
2005-11-15/13:03
Advertisement
Table of Contents
