Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Chamberlain Power Drive 3132E FS2 Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rolling code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚

To Add or reprogram a Hand-held Remote Control

USING THE LIGHTED DOOR CONTROL
1. Remove the cover from the
Lighted Door Control.
2. Press and hold the button on the
hand-held remote* that you wish
to operate your garage door.
3. While holding the remote button,
press and hold the "A" button on
the Lighted Door Control.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the "learn" button on
motor unit until the learn indicator
light goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or
keyless entry you wish to use.
® garage door opener is operated with a non-rolling code transmitter, the technical
4. Continue holding both buttons
while you press the "B" button on
the Lighted Door Control (all three
buttons are held).
5. Release buttons when the motor
unit lights blink. It has learned the
code. If light bulbs are not
installed, two clicks will be heard.

*3-Button Remotes

If provided with your
garage door opener,
the large button is
factory programmed to
operate it. Additional
buttons on any
Security✚ ® 3-button
remote or mini-remote can be programmed to operate
other Security✚ ® garage door openers.
36
remote controls.
®
"A"
Button
"B"
Button
"A"
Button
"B"
Button