How To Initialize The Lcd Tv - Philips 75PFL5704/F7 Service Manual

HOW TO INITIALIZE THE LCD TV

The purpose of initialization is to place the set in a new out of box condition. The customer will be prompted to
select a language and program channels after the set has been initialized.
To put the program back at the factory-default, initialize the LCD TV using the following procedure.
Note: Disconnect any device from the USB Port
before you conduct on this procedure.
[TYPE A]
1. Turn the power on.
2. Enter the service mode.
3. Press [ (INFO)] button on the remote control unit
to proceed with the self check mode.
4. [If the firmware version is "UNI-0W0LU_102_0"
or older]
Make sure to confirm the "INITIALIZED: OK"
appears in the green screen.
[If the firmware version is "UNI-0W0LU_103_0"
or newer, Or If the firmware version is "UNI-
0X0LU_xxx_x"]
Make sure to confirm the Initial settings menu
appears.
Note: It will take long time. (around 4minutes)
5. Unplug the AC Cord and plug it back on again.
[TYPE B]
Please use the: Remote control unit (Philips Smart
& Magnavox Smart: RC6 code)
1. According to above steps, enter into the service
mode.
- To cancel the service mode, press [ ] button on
the remote control unit.
2. Press [Red], [2], [7], [3] buttons to implement
forced the initialized.
3. Make sure to confirm the "INITIALIZED FINISH"
appears in the green screen.
4. Unplug the AC Cord and plug it back on again.
6-1 PL19.29INT