Lcd & Keypad - GE Zenith Controls MX150 Operation And Maintenance Manual

MX150 Microprocessor Controller
LCD & Keypad
These options are accessible through the LCD and
keypad (see figure below). To become familiar with the
options loaded into a particular unit, scrolling through
the SET and CFG menu will show the descriptions of
the options (see pages 16). These menus are the very
same menus that are used to access the setting and/or
configuration of these options. The SET (setting) menu
is primarily used to show or change, time and voltage
settings. The CFG menu is primarily used to turn an
option on or off. When scrolling through these menus,
Source 1 LED (Green)
indicates Source 1 is
acceptable for use
LCD Screen
Current Time,
Day and
Date of Display
#1 or the word
on the LCD above the key.
The word above the key
changes depending on which
screen is being displayed.
8
MX150 Operation and Maintenance Manual (70
Source 2 Position
LED (Red) indicates
Power Panel (ATS)
Source 1 Position LED (Green)
is closed to
indicates Power Panel (ATS)
Source 2 position
is closed to Source 1 position
S 1 O K
01: 50
F R I 3 1 M AY 20 03
MO R E C FG TEST
MORE Menu CFG Menu
MX150
#2 or the word
on the LCD above the key.
The word above the key
changes depending on which
screen is being displayed.
Figure 8
no changes can be made without entry of the access code.
The factory set six-digit access code is located on a white
label on the back of the unit (see figure 9 pgs. 16-18).
The MX150 has many logic options. Each controller is
downloaded with options at the time of manufacture.
The collection of options that any one controller has is
specified at the time of order placement. The following
pages include all the options that can reside in the
controller. Not all units include all options.
Source 2 (Red)
indicates Source 2
is acceptable for use
* E *
S ET
Keypad
TEST Menu
#3 or the word
on the LCD above the key.
The word above the key
changes depending on which
screen is being displayed.
R -2000)
(cont'd)
Exercise Event
"Impending"
SET Menu
#4 or the word
on the LCD above the key.
The word above the key
changes depending on which
screen is being displayed.
GE Zenith Controls