Hamilton Beach Professional Digital 41028-SC Manual page 6

To change the Start Time if previously set, press and hold the PROG
button for 2 seconds and the Prog light will flash. Change settings as
previously described. Prog light will turn off after 3 seconds to confirm
the Start Time setting. Press the PROG button to activate the Start
Time. The light will illuminate to confirm setting.
If no change is being made to the Start Time, press the PROG button
to activate the Start Time. The light will illuminate to confirm setting.
When the Start Time equals the actual time, the Prog light will shut off
and the ON/OFF light will be illuminated. The Start Time, Preset Time,
and Keep Warm time (if it has been set) will be stored in the memory.
When the Start Time has elapsed, the base will chime two times and
switch to Keep Warm. Once the Keep Warm time has elapsed, the base
will double-chime three times and shut off.
If kettle floor discolors: It is normal for stainless steel heating elements
to discolor. This does not affect the performance of the Kettle. Do not
use abrasive scouring pads or cleaners since this may damage the
stainless steel surface.
If Kettle boils dry: The heating element is protected by two automatic
safety devices. If your Kettle is accidentally switched on without being
filled with water, or is allowed to boil dry, the Kettle will automatically
switch off and display will show "---".
You should:
• Press ON/OFF (I/ ) button to turn OFF ( ), unplug, and wait about
20 minutes for the element to cool
• Refill the kettle; then use as normal and check that the Kettle
functions correctly.
6
If Kettle does not work: Make these simple checks before calling the
toll-free customer assistance number:
• Have you pressed the ON/OFF (I/ ) button to ON (l) position?
• If the Kettle heats but does not boil, it might need descaling
(see "Care and cleaning" section).
• Has the Kettle been accidentally turned on without being filled with
water or allowed to boil dry? Press the ON/OFF (I/ ) button to
OFF ( ), wait 20 minutes, and try again.
• Is cord firmly plugged into the outlet and Kettle firmly seated in
the base?
Anti-Scale Mesh Filter: Scale is caused by
lime and calcium in hard water. The Mesh Filter
will prevent these suspended particles from
being poured out of the Kettle. The filter should
be cleaned periodically to ensure optimum
performance.
To clean the filter, unplug Kettle and allow to
cool. Pull up on the filter tab to slide filter out.
To replace filter, line up the filter with tab
towards the inside of the Kettle and slide into
place until it snaps into place.