How To Use The Kettle - Hamilton Beach Professional Digital 41028-SC Manual

How to Use the Kettle

BEFORE FIRST USE: Flip open lid and fill Kettle with water to the MAX fill line on the Water Level Window. Press ON/OFF (I/ ) button to turn the
Kettle ON (I). The Kettle will bring the water to a boil, then shut off automatically. Discard water and repeat 2–3 times, rinsing out the kettle each
time. The Kettle is now ready for use.
1. Plug into outlet. The base will chime and display the Plug into outlet.
The base will chime and display the current kettle temperature; the
current time will flash 0:00; the start time will show 19:99; the keep
warm time will show 0; and the default temperature setting "212°F
(100°C) Black Tea/Herbal Tea/Boil" will show.
2. Set time by pressing HOUR button until correct hour is displayed
in AM or PM, then press MINUTE button until the current time is
displayed.
3. Set the temperature display to °F or °C by pressing PRESET TEMP
and KEEP WARM simultaneously.
Boiling Water
Press the ON/OFF (I/ ) button and the light ring will show red to
indicate heating. The base will show the current temperature of the
water. As the water is heated, the segments on the thermometer icon
will display at the preset temperature intervals. Once the Kettle has
finished and the water is boiling, the base will double-chime three times.
Changing Preset Temperatures
Press the PRESET TEMP button to scroll down the thermometer icon
until the desired preset temperature is highlighted.
If the water temperature in the Kettle is above the preset temperature,
the base will double-chime three times and shut off automatically.
Be sure that the preset temperature is higher than the water
temperature in the Kettle.
Burn Hazard. Do not overfill kettle.
CAUTION
Boiling water may spit out of the spout.
Setting a Keep Warm Time
Press the KEEP WARM button anytime before the heating cycle ends.
To set the desired Keep Warm time, press the KEEP WARM button until
the desired Keep Warm time is displayed. Once the preset temperature
has been reached, the base will double-chime three times and start the
Keep Warm countdown timer counting down in 1-minute increments.
When the timer is finished counting down, the base will double-chime
three times and turn off automatically.
Programming a Start Time
Make sure that the current time is set correctly on the base. Press and
hold the PROG button for 2 seconds and "Start Time" will flash. If the
preset temperature is set to 212ºF (100ºC), the Preset Temp will default
to the lowest setting of 160ºF (70ºC).
The default start time is 19:99. Change the default time by pressing the
HOUR button until correct hour is displayed in AM or PM, then press
MINUTE button to set desired time. After 3 seconds the Start Time
clock will stop flashing to confirm setting is complete. Press the PROG
button again to activate the Start Time function. A red light will illuminate
around the PROG button to confirm Start Time setting.
NOTE: "212ºF (100°C) Black Tea/Herbal Tea/Boil" is not available for the
Start Time setting.
5