Important Safety Instructions; Directions For Use - Guardian GG3000 Use & Care Instructions Manual

UV-C Light Bulb & Filter
Ultraviolet light technology, the same technology used in hospitals and commercial settings for
sanitizing, is capable of eradicating microorganisms, mold spores and viral contaminants from the air.
It is recommended that you leave the GermGuardian UV-C Air Sanitizer running continuously.
A replaceable 9-watt UV-C light bulb should last approximately 6,000 hours, this number could
vary in some circumstances. A filter that helps reduce odors is also in the product and should be
replaced once a year. Over time, with use, the 9-watt UV-C bulb will lose some intensity
(about 15% at 9,000 hours), therefore it is suggested that the light bulb be replaced once every year.
You will know when to change the 9-watt light bulb when it continuously flickers or changes color.
The replacement bulb and filter come in one package.
WARNING: Electrical Shock
UNDER NO CIRCUMSTANCES SHOULD YOU CLEAN THE BULB, BULB
HOLDER OR CYLINDER WITH WATER OR WET SOLUTIONS. THIS COULD
CAUSE ELECTRICAL SHOCK.
Use of the GermGuardian Unit
When the GermGuardian is turned on you will see five dots of blue light that let you know it is
working. Depending on dust conditions and build-up, you may need to occasionally clean the
bulb and cylinder with a soft, dry cloth. This product is safe for use around children and pets,
and is cool to the touch.

Directions for Use

1. Plug unit into a 120V AC electric outlet.
2. Press the power button. The ring will illuminate
around the button.
3. Press the power button to adjust the fan speed.
(Bright blue is HIGH, Light blue is LOW).
4. For best results continuous operation is recommended.
5. To turn off the unit press and hold power button
for five seconds.
NOTE: THE GERMGUARDIAN UNIT CONTAINS NO
SERVICEABLE PARTS EXCEPT ITS UV-C BULB AND
FILTER. THE BULB AND FILTER MAY BE REMOVED
FOR REPLACEMENT.
E-4

IMPORTANT SAFETY INSTRUCTIONS

WARNING: Electrical Shock
ALWAYS UNPLUG THE GERMGUARDIAN UNIT
FROM ELECTRICAL OUTLET WHEN SERVICING.
Replacing and Cleaning the UV-C Bulb & Filter
1. Turn off the unit and unplug it from the electrical outlet.
2. Using a small phillips head screwdriver, loosen and
remove the phillips screw located at the top of the unit,
above the power cord.
3. Remove the top cap by lifting its side near the screw hole,
then gently push the cap in the opposite direction.
4. As the cap loosens, you may lift it off.
5. Remove the (2) phillips screws
located on each side of the bulb
holder and remove the filter.
E-5