Exmark COMMERCIAL 30 Operator's Manual page 17

Figure 13
• Front Wheel Adjustment
1. Pull up on the height lock and pull the front
wheel shaft assembly outward as shown in
Figure 14.
Figure 14
1. Front wheel shaft
assembly
2. Pull up
3. Height lock
2. Insert the front wheel shaft assembly into the
desired cut height setting in the front quadrant
block. Lower the height lock into the groove
on the front wheel shaft. Pull and push the
wheel shaft assembly to make sure it has
locked into place.
g016520
g195299
4. Front quadrant block cut
heights
5. Pull outward
6. Shaft groove
1. Front quadrant block
Using the Grass Bag
• Installing the Grass Bag
1. Release the blade control lock lever and wait
for the blade and all moving parts to stop.
2. If the mulch plug is installed on the mower,
remove it (refer to Removing the Mulch Plug).
If the side discharge deflector is on, remove it
and install the side discharge door (refer to
Using the Side Discharge Deflector).
3. Open the rear discharge door.
4. Grasp the handle on the bag and set the rear
of the bag frame onto the handle bracket
notch (Figure 16).
1. Bag
2. Handle
3. Bag frame
5. Once the bag is seated, lower the rear
discharge door onto the bag.
17
Operation
Figure 15
2. Cutting heights
Figure 16
4. Handle bracket notch
5. Rear door
6. Lower
g016521
g017969