Using A Microphone; Clock And Timers - Panasonic SC-UA7 Owner's Manual

Using a microphone

Preparation
Lower the volume of the system to its minimum before
you connect or disconnect a microphone.
1
Connect a microphone (not supplied) to the
microphone jack.
Plug type: Ø 6.3 mm ( 1
2
Press [MIC VOL/KARAOKE EFFECT] to select
"MIC VOL".
3
Press [Y, U] to adjust the volume of the
microphone.
If you want to sing with the background music.
4
Play the music source and adjust the volume of
the system.
Note:
•
If a strange noise (howling) is emitted, move the
microphone away from the speakers, or lower the volume
of the microphone.
•
When you do not use the microphone, disconnect it from
the microphone jack, and lower the volume of the
microphone to its minimum.

Clock and timers

Setting the clock
This is a 12-hour clock.
1
Press [SETUP] to select "CLOCK".
2
Press [Y, U] to set the time and then press [OK].
To check the time
Press [SETUP] to select "CLOCK" and then press
[OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
") monaural
/
4
Sleep timer
The sleep timer turns off the system after the set time.
Press [SLEEP] to select the setting (in minutes).
To cancel, select "OFF".
To check the remaining time
Press [SLEEP].
Note:
•
The remaining time is shown for a few seconds every
minute. "SLEEP 1" is always shown when only 1 minute
remains.
•
The play timer and sleep timer can be used together.
•
The sleep timer always comes first. Be sure not to set an
overlapping time.
Play timer
(Except for Bluetooth ® , D-IN, AUX 1 and AUX 2 source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] to select "TIMER ADJ".
2
Press [Y, U] to set the start time and then press
[OK].
3
Re-do step 2 to set the end time.
4
Press [Y, U] to select the source you want to play
and then press [OK].
To start the timer
1
Prepare the source you want to listen to (USB or
radio) and set the volume.
2
Press [SETUP] to select "TIMER SET".
3
Press [Y, U] to select "PLAY ON" and then press
[OK].
"#" is shown.
To cancel, select "PLAY OFF".
The system must be turned off for the timer to operate.
To check the setting
Press [SETUP] to select "TIMER ADJ" and then press
[OK].
In standby mode, press [DISPLAY] two times.
Note:
•
The timer starts at a low volume and increases gradually to
the preset level.
•
The timer comes on at the set time every day.
•
If you turn off the system and then turn on again while a
timer is in operation, the timer will not stop at the end time.
13