Canon MultiPASS L6000 Quick Start Manual page 18

Starting the Installation Procedure
Important!
you must use the MultiPASS Uninstaller to remove it before beginning installation of the
MultiPASS L6000. See your User's Manual for details.
1
Start up
your system
in this order.
2
Make sure
If Windows recognizes the MultiPASS:
Windows 95
starts.
Be sure to wait
for Windows
to complete
each operation.
If you have a previous version of the MultiPASS Desktop Manager installed,
It's important to follow this order for the Windows 95 Plug and Play feature
to work:
1. Make sure your computer is turned OFF.
2. Be sure the MultiPASS L6000 is plugged in and connected to the computer.
3. Now turn on the computer.
You see a screen similar to this:
Insert the Install Me First CD
into your CD drive.
Make sure "Driver from disk provided
by hardware manufacturer" is selected
and click OK.
You see this screen:
In this box, type D: \ (where D:is
your CD drive... most CD drives
are either D: or E:). Make sure the
Install Me First CD is in your
CD drive and then click OK.
*
If this is not the screen you see (instead
you see the Update Device Wizard),
please see the Installation slip sheet that
came in the box for instructions.
If the "New Hardware Found"
dialog box does not appear:
Insert the
*
Install Me First CD
into your CD drive.
If AutoRun is enabled,
installation starts immediately.
(Go to step 3 on the next page.)
If installation doesn't start,
from the taskbar, click Start
and then Run.
You see this screen:
In this box, type D: \SETUP
(where D:is your CD drive...
most CD drives are D: or E:).
Then click OK.
17