Installation Procedures; Installing User Software - Canon imageCLASS D320 Printer Manual

Installation Procedures

Installation Procedures Installation Procedures Installation Procedures
This section describes how to install CARPS using Setup Wizard, Plug and Play, and Add
Printer Wizard.

Installing User Software

Installing User Software Installing User Software Installing User Software
If you want to configure the port setting and your operating system is Windows 2000/XP,
follow the steps in "Installing Printer Driver without a USB Connection" on page 2-6. If
not, follow the steps in "Installing Printer Driver through a USB Connection" on page 2-3.
Installing Printer Driver through a USB Connection Installing Printer Driver through a USB Connection Installing Printer Driver through a USB Connection Installing Printer Driver through a USB Connection
I I I I
The following is the installation procedure of the user software using a USB connection, under
Windows 98/Me/2000/XP.
The screen shots shown are from Windows 2000.
1 Make sure the machine is not connected to your computer and it is turned on.
• Do not connect the USB cable to the port on your computer at this time. During the
installation of the software, the installation program will prompt you when it is
IMPORTANT
appropriate to connect the machine to your computer.
• If you are using Windows 2000/XP, be sure to log on as member of Administrators.
The full control access right for the printer is necessary for the installation of
CARPS.
2 Place the CD-ROM into your CD-ROM drive. The installation starts automatically.
If the installation does not start automatically, select Run from the Start menu
"D:\Drivers\us_eng\prnsetup\Setup.exe" (if your CD-ROM drive is drive "D:") in the
NOTE
command line click OK.
2
type
2-3