Operation; Switching On / Off; Setting The Cutting Depth - Parkside PGG 15 A1 Operation And Safety Notes

Operation

Never use the device for a purpose for which it was not intended or
with non-original parts / accessories. The use of tools or accessories
other than those recommended in the operating instructions could lead
to you suffering an injury.

Switching on / off

Insert the mains plug into a mains socket.
Switching on:
Press the ON / OFF switch
Switching off:
Release the ON / OFF switch

Setting the cutting depth

The cutting depth of the engraver is set using the stroke rate rotary control-
ler . A low setting is usually sufficient for most common applications.
2
Turn the stroke rate rotary controller
crease the cutting depth.
Turn the stroke rate rotary controller
Note: Take care when increasing the cutting depth not to turn the stroke
rate rotary controller
could screw off the device.
.
1
.
1
too far towards the + sign. Otherwise the switch
2
towards the + sign to in-
2
-
towards the
2
Operation
depth.
GB/MT 61