Page 1
Serial #: ___________________________ Date Purchased: _____________________ Installation & Operation Manual Gas Power Tilt Skillets GLTS-30 & GLTS-40 Model GLTS-40 WARNING Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment.
Gas Power Tilt Skillets Table of Contents RETAIN THIS MANUAL FOR FUTURE REFERENCE. Table of Contents Important Notes For Installation and Operation ..............2 Service Connections ......................4 Installation Instructions ......................5 Operation ..........................7 Periodic Maintenance ......................10 Cooking Guidelines ....................... 11 Troubleshooting ........................
Gas Power Tilt Skillets NSTALLATION NSTALLATION NSTRUCTIONS NPACKING IMMEDIATELY INSPECT FOR SHIPPING DAMAGE Immediately after unpacking the steamer, check for possible shipping damage. If the steamer is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery. Prior to installation, verify that the type of gas supply (natural or propane) and electrical service agree with the specifications on the rating plate located on the left side panel as you face the front of the braising pan.
Page 6
Gas Power Tilt Skillets NSTALLATION eveling and nchoring 1. Set the appliance in place and level left to right and front-to-back using spirit level. 2. Mark hole locations on floor through anchoring holes provided in flanged adjustable feet. 3. Remove appliance and drill holes in locations marked on floor and insert proper anchoring devices (not supplied). 4.
Gas Power Tilt Skillets PERATION PERATION NOTICE If this equipment is being installed at over 2,000 feet altitude and was not so specified on order, contact service department. Failure to install with proper orifice sizing may void the warranty. Before First Use Using a non-corrosive, grease-dissolving commercial cleaner, clean the protective metal oils from all surface parts and the interior of the tilting braising pan.
Page 8
Gas Power Tilt Skillets PERATION 6. If gas supply is interrupted during operation, turn THERMOSTAT dial to OFF position and turn gas supply OFF. Wait 5 minutes, then repeat Steps 1 through 4 to restart. 7. Turn power switch and THERMOSTAT to OFF when braising pan is not in use. CAUTION If you smell gas during the lighting procedure, immediately shut off the gas supply until the leak has been corrected.
Page 9
Gas Power Tilt Skillets Preventative Maintenance Preventative Maintenance WARNING Disconnect the power supply to the appliance before cleaning or servicing. CAUTION Do not use cleaning agents that are corrosive. CAUTION Operating, testing, and servicing should only be performed by qualified personnel. Cleaning After each use, allow the tilting braising pan to cool and clean it.
Preventative Maintenance Gas Power Tilt Skillets CAUTION The appliance and its parts are hot. Use care when operating, cleaning and servicing the appliance. WARNING Disconnect the power supply to the appliance before cleaning or servicing. Adjustments All tilting braising pans are adjusted at the factory. At least twice a year, have an authorized service person clean and adjust the tilting braising pan for maximum performance.
Gas Power Tilt Skillets ROUBLESHOOTING ROUBLESHOOTING Burners No Not Come On 1. Gas supply to unit is “OFF”. 2. Manual shut off valve is “OFF”. 3. Thermostat is not turned “ON”. 4. Pan not in lowest position. 5. Ignition control not functioning. 6.
Page 15
Gas Power Tilt Skillets Notes INSTALLATION & OPERATION MANUAL 10100 REV 0 (04/21) PAGE OF16...
Page 16
Gas Power Tilt Skillets A product with the Crown name incorporates the best in durability and low maintenance. We all recognize, however, that replacement parts and occasional professional service may be necessary to extend the useful life of this appliance.