Replace Davco 382 Fuel Pro®Fuel/Water Separator Element - Detroit Diesel EPA07 MBE 4000 Operator's Manual

Hide thumbs Also See for EPA07 MBE 4000:
Table of Contents

Advertisement

HOW-TO SECTION
NOTE:
Do not use tools to tighten the prefilter
element.
8. Tighten the drain plug.
9. Prime the fuel system.
[a] If equipped with a hand pump
on the fuel/water separator,
work the hand pump until
resistance is felt.
NOTE:
There should be a strong resistance
in the hand pump, caused by the
pressure build-up within the fuel
system.
[b] Crank the engine for 30
seconds at a time, but no
longer. Before cranking the
engine again, wait at least two
minutes. The engine should
start within four 30 second
attempts.
Replace Davco 382 Fuel
Pro®Fuel/Water Separator
Element
Replace the fuel/water separator
element as follows:
92
DDC-SVC-MAN-0041
Figure 39
All information subject to change without notice.
Copyright © 2009 DETROIT DIESEL CORPORATION
Davco 382 Fuel
Pro®Fuel/Water
Separator

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents