7- Mechanical Adjustment - Saturn LAWA-A Manual

7- Mechanical adjustment

1. Put label roll on the label plate.
2. When the label through the label head, pay special attention to the stacker paper get
though the sensor's correlation center, make sure the sensor can check the labels.
3. Adjust the press product device depends on the product height, make sure the
distance between conveyor and press product device bottom 2-3mm less than product
height.
4. Adjust the Neaten product device depends on product width, make sure the distance
2-3m less than the product width.
5. Adjust the label head depends on product width, keep the distance between peel label
device and product one side about 4-5mm.
6. Label testing: put some products on the conveyor, open the main switch, observe
the send label height on the product body, then adjust the label head up and down
adjustment hand wheel to amend the label position on the product.
7. There are two sets roll label device.