Table of Contents
Advertisement
EMBALLAGE SATURN PACKAGING / LAWA-A
Label Speed:
Setup the unit label peeled out speed .The speed is controlled by the
step motor, which is the controller issued frequency control pulse, unite is HZ.
Label
plus:Setting amount for protecting labeling system, setting 3000-5000 is ok,
after setting, don't need change
Label Delay :
Label peeled out Delay time . When the sensor detect the product
reach the preset time , the label will be peeled out .
Code time :
printing time
Label pos :
This setting don't need change .
Code on:
the printer device have off, if need use the printer, touch again.
test label to make sure the label position is ok before labeling
Label test :
Space motor:
The start-stop control button of separate product motor
The start-stop control button of conveyor belt 、 pressure product
Main motor:
institution and separate product motor.
RUN:
Start the machine
Alarm reset:
eliminate alarm, close alarm button when the machine have
malfunction.
2.
The sequence of operations
①. Starting up
(1) Rotating the master switch (front side of electrical cabinet), the yellow light
bright when the total power on.
(2) The touch screen enter the operation interface, click start button, set up the
parameter as Figure (2).
10 |
P a g e
Advertisement
Table of Contents
