Installation - Haier HRF-330WDBG Instruction Manual

Suggestion
Relocation of refrigerator.
Disconnect the power cord.
Remove water from the evaporating tray.
Take food out of the refrigerator compartments.
Fasten the doors with tape while moving to prevent them from opening
For safety, use 2 people to carry the refrigerator.
Do not lift the unit in a horizontal angle, however, it may be 45 degrees
tilted slightly.

INSTALLATION

1. Select a place with strong, level floor. If the floor is not quite level, adjust the height of
the screw accordingly.
2. Allow sufficient clearance adequate space around the refrigerator, so the door
can open fully and to minimize noise.
3. Avoid direct sunlight and heat. Direct sunlight may affect the enamel coating.
Heat sources nearby will cause higher electricity consumption.
Avoid very moist place. Too much moisture in the air will cause frost to f m very quickly
4.
on the evaporator, and the refrigerator will have to be defrost very frequently.
Don t connect multiple appliances to '
5.
It may cause fire. To avoid the possibility of electrical shock, ground the refrigerator
properly. The earth screw is located on the rear side of the refrigerator.
6. In case of customer desire to add the ground wire with Earth Screw junction earth
symbol at the back of the refrigerator. Should attach the ground wire to metal
pipe or to cover screw of the wall receptacle or to a rod buried at least 2.4 meters
in the ground.
7. After re-located, leave the fridge statically 3-6 hours before switching it on. This
to ensure a proper cooling system operation.
10 cm.
the save energy source
30 cm.
15 cm.
4
or
.
is
Refrigerator
Unit
2.4 meters
Ground Wire