Printing The Test Patterns Or Lists - Brother HL-2400C Series User Manual

USER'S GUIDE

Printing the Test Patterns or Lists

2–18
You can check print quality and print a list of available fonts before you
actually start working with the printer. To do so, follow these steps:
1. Make sure that you have already installed the toner cartridges, the
(OPC) Belt Cartridge, the Oil Bottle and the Fuser Cleaner and have
loaded paper into the cassette. Make sure that you have removed the
protective parts on the Waste Toner Pack.
2 Turn on the printer. Wait until the display shows the message as
follows.
LJ READY 001P T1
AUTO
3. Press the Sel button to set the printer off-line.
The On Line LED goes off.
4. Hold down the Shift button and press the Test button.
5. Press the or button to scroll through the display until the desired
message appears. To print your selection, press the Set button.
Choose from one of the following selections :
To Print Out
the Demonstration Page
the Test Pattern
the list of printer settings
the list of internal or resident fonts
the list of optional cartridge/card fonts
the list of permanent download fonts
To exit from the test mode, select "
Notes
The messages "PRINT FONTS C" or "PRINT FONTS P" appear only
when an optional font cartridge/card is installed in the font slot or
permanent download fonts are stored in printer memory respectively.

If the optional font cartridge/card is installed, you can print out a list
of optional fonts. Since the list shows the ID numbers specific to each
optional font, it helps you to select them with the Font button. For
further information, see "FONT Button" in Chapter 4.

If user-defined characters are already downloaded into the printer
memory as permanent download fonts, you can print out a list of
them. For further information, see "FONT Button" in Chapter 4.





K C M Y
LCD Message in the Second Row
DEMO PAGE
TEST PRINT
PRINT CONFIG
PRINT FONTS I
PRINT FONTS C
PRINT FONTS P
exit
".