DeWalt H-8902 Troubleshooting

H-8902
DEWALT 12 GALLON
®
WET/DRY VACUUM
WARNING: To reduce the risk of injury from moving parts and/or electrical shock, turn power switch off and
disconnect grounded plug from electrical outlet before performing troubleshooting checks.
OPERATING ISSUE
Motor does not run.
Suction capacity
decreases.
Vacuum stops running.
Dust comes out while
vacuuming.
PAGE 1 OF 3
1-800-295-5510
uline.com
TROUBLESHOOTING
RECOMMENDATIONS
Check power cord, plugs and outlet.
Ensure on/off switch is in ON position.
Remove blockages in suction nozzle, suction tube, hose or filter.
Replace filter bag.
Check for proper installation of filter.
Clean or replace filters.
Empty canister and refer to Empty Tank in instruction manual.
Thermal overload has been tripped:
1. Turn off vacuum and disconnect from power source.
2. Empty canister, if needed.
3. Allow unit to cool.
4. Plug power cord into appropriate outlet and turn on/off switch
to ON position to test. If vacuum will not restart call Uline
Customer Service at 1-800-295-5510.
Check for proper installation of filter.
Ensure filter is not damaged; replace if necessary.
Ensure filter seals are in place and are secure.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0421 TH-8902