Product Maintenance; Troubleshooting - Fellowes POWERSHRED 79Ci Manual

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250

TROUBLESHOOTING

will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the
continuous operation and recovery time for this shredder.
SafeSense ® Indicator: If hands are too close to the paper entry, the SafeSense
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
JAM PROOF SYSTEM*
Eliminates paper jams and powers through tough jobs.
DISABLING THE FEATURE
1
Should you choose to disable Once disabled, the blue
the system, press and hold Auto light is no longer
the auto button (blue) and illuminated (To re-engage,
reverse ( ) key at the repeat step 1)
same time
*100% Jam Proof when used in accordance with user manual
4
2
3
AUTO
Shredding can continue with
the system disabled, however a
paper jam may occur with too
many sheets and Remove
Paper icon (
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1 2
Turn off and unplug Locate Auto-start
shredder infrared sensor
® indicator will illuminate and the shredder will stop shredding. If SafeSense
5 3 4
If jam occurs, press and
hold forward ( ) key until
the document is completely
through the shredder
) will illuminate
.
4
3
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
®
3 5
5 6
If not cleared, press If steps 4 and 5 do not clear
jam, reverse paper all the
reverse ( ) briefly
(repeat steps 4 and 5 way out, remove several
until shredded) sheets and refeed
ENGLISH
Model 79Ci