Brother XL-2230 Operation Manual page 57

APPENDIX —————————————————————————————————————————————————————
8 Check that the edge of the race shelf is
positioned as in step
shuttle in so that the projection on the shuttle
lines up with the spring.
2
1
1 Projection
2 Spring
9
Put the tabs on the needle plate cover into the
needle plate, and then slide the cover back on.
CAUTION
●
Never use a shuttle that is scratched,
otherwise the upper thread may become
tangled, the needle may break or sewing
performance may suffer. For a new
shuttle (part code: XC3152-021), contact
your nearest authorized service center.
●
Make sure that you fit the shuttle
properly, otherwise the needle may
break.
56
5
, and then put the
1
2