Brother XL-2230 Operation Manual page 20

4 While holding the end of the thread, gently
press the foot controller to wind the thread
around the bobbin a few times. Then stop the
machine.
5 Trim the excess thread above the bobbin.
6
Press the foot controller to start.
7 After the machine stops automatically when
the bobbin is full, take your foot off the foot
controller.
8 Cut the thread, slide the bobbin-winder shaft
to the left and remove the bobbin.
Note
● The needle bar does not move when you
slide the bobbin-winding shaft to the right.
● Immediately after winding the bobbin, it is
normal to hear the sound of the clutch
engaging when beginning to sew or turning
the balance wheel.
CAUTION
●
Make sure you follow the instructions
carefully. If you do not cut the thread
completely, and the bobbin is wound,
when the thread runs low it may tangle
around the bobbin and cause the needle
to break.
CAUTION
●
Not setting the bobbin properly may
cause the thread tension to loosen, and
may break the needle.
1
1 Wound evenly
2 Wound poorly
1
2
19