Tractor Operation - Snapper SPX Series Operator's Manual

4. Engage the parking brake control (I, Figure 8). Push the
brake pedal, pull OUT the parking brake control, and
release the brake pedal.
8
5. Push the PTO switch (E) to disengage it.
6. Set the throttle/choke control (J) to the CHOKE position (if
equipped).
7. Put the key into the ignition switch (C) and turn it to the
START position. For push-button start models, push the
button two times and hold until the engine starts.
8. After the engine starts, move the throttle/choke control
to half speed. Make sure that the engine is ON for a
minimum of 30 seconds. This will warm the engine.
9. Set the throttle/choke control to the FAST position.
Note: In the event of an emergency, turn the ignition switch
to the OFF position. This will STOP the engine. See Stop the
Engine.
Note: If the engine does not start after 2 or 3 attempts,
contact an Authorized Service Dealer.
Stop the Engine
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
• Do not choke the carburetor to stop the engine.
1. Release the ground speed pedals (O, Figure 9).
12
9
2. Disengage the Power Take-Off (PTO) switch (E). Wait for
all moving parts to stop.
3. Move the throttle control (J) to the SLOW position.
4. Turn the ignition key switch (C) to the OFF position.
Remove the key.
5. Engage the parking brake control (I). Push the brake
pedal (U), pull UP on the parking brake control, and
release the brake pedal.
In the event of an emergency, turn the ignition switch to the
OFF position. This will STOP engine.

Tractor Operation

1. Sit in the seat and adjust the seat so that you can
comfortably reach all the controls. See Features and
Controls.
2. Engage the parking brake:
A. Fully push DOWN on the brake pedal.
B. Pull UP on the parking brake control.