❷ Installati On; I Preparing The Pool; I Installati On Principle - Polaris QUATTRO Instructions For Installation And Use Manual

❷ Installati on

2.1 I Preparing the pool

• For opti mal operati on, the pool water must meet the following conditi ons:
Water temperature
Chlorine
• Stop the fi ltrati on pump, allow to prime.
• Start the booster pump. Bleed the water circuit for 5 minutes.
• Stop the fi lter pump and booster pump.
• When the pool is dirty, especially when fi rst installing the cleaner, remove the largest debris using a manual brush
and a net.
• Remove any thermometers, toys and other objects that might damage the appliance.
Tip: To maintain the cleaner in good conditi on
Aft er cleaning or backwashing, run the fi ltrati on system for at least fi ve minutes before reconnecti ng the
cleaner.

2.2 I Installati on principle

pH
Between 15°C and 35°C
Between 6.8 and 7.6
< 3 mg/ l
: The water is sucked by the
pump via the skimmers and fl oor
drain.
: The water is sent to the fi lter to
be cleaned.
: The clean water is discharged
into the pool return lines.
: A deviati on is created on this
piping to supply the booster pump.
: Polaris® pressure cleaners
are connected to the wall fi tti ng
transformed into a discharge port
: The venturi eff ect generated
by the jets transforms the water
supply into a powerful sucti on
current and allows the cleaner to
move.
EN
5