Setting Up "Spp (Bluetooth Classic) - Panasonic PAN1326C2 Quick Start Manual


PAN1326C2 Bluetooth Module

4.5 Setting up "SPP (Bluetooth Classic)"

This chapter explains how to set up the demo "SPP" which is based on Bluetooth Classic.
The following requirements must be met:
✓ The demo is loaded
✓ The evaluation board is connected
✓ The code is flashed
Setting the Evaluation Board as Server
1. Download a Serial terminal program. In this guide "PuTTY" is used.
2. Open the terminal program and select the connection type Serial.
3. Set the assigned COM port to the evaluation board (in this case "COM4") and set the
speed to 115 200 kBit/s.
4. Enter Server in the prompt Choose Mode> (1) to set the evaluation board as server.
5. Entering Open 1 in the prompt Server> (2) to open a server port.
➔ The evaluation board is set as server.
Quick Start Guide Rev. 1.0
 4.1 Loading the
Demo.
 4.2 Connecting the Evaluation
 4.3 Flashing the
Code.
You can replace "1" with any number between 1 and 30, if there is no
server open on that port.
4 Setting up the Demo
Board.
Page 15 of 20