Brother HL-8050N Quick Setup Manual page 9

■ Safety Precautions
For Finland and Sweden
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
☛ Varoitus!
Laitteen käyttäminen muulla kuin tässä käyttöohjeessa
mainitulla tavalla saattaa altistaa käyttäjän
turvallisuusluokan 1 ylittävälle näkymättömälle
lasersäteilylle.
☛ Varning
Om apparaten används på annat sätt än i denna
Bruksanvisning specificerats, kan användaren utsättas för
osynlig laserstrålning, som överskrider gränsen för
laserklass 1.
Internal laser radiation
Maximum radiation power: 5 mW
Wave length:
Laser class:
IMPORTANT - For Your Safety
To ensure safe operation the three-pin plug supplied must be inserted only
into a standard three-pin power outlet/socket which is properly grounded/
earthed through the normal standard wiring.
Extension cords should not be used the equipment. If it is essential that an
extension cord has to be used, it must be three-pin plug type and correctly
wired to provide proper grounding/earthing. Incorrectly wired extension cords
may cause personal injury and equipment damage.
The fact that the equipment operates satisfactorily does not imply that the
power is grounded/earthed and that the installation is completely safe. For
your safety, if in any doubt about the effective grounding/earthing of the
power, call a qualified electrician.
Disconnect device
This printer must be installed near an AC power outlet/socket that is easily
accessible. In case of emergencies, you must disconnect the power cord
from the power outlet/socket to shut off the power completely.
Caution for batteries
Do not replace the battery. There is a danger of explosion if the battery is
incorrectly replaced. Do not disassemble, recharge or dispose of in a fire.
Used batteries should be disposed of according to local regulations.
Opmerking / Oplaadbare Batterij Recycle Informatie (For
Netherlands Only)
Bij dit product zijn batterijen geleverd. Wanneer deze
leeg zijn, moet u ze niet weggooien maar inleveren
als Klein Chemisch Afval.
Geräuschemission / Acoustic noise emission (for Germany
only)
Lpa < 70 dB (A) DIN 45635-19-01-KL2
Radio Interference (220 to 240 Volt Model Only)
This printer complies with EN55022 (CISPR Publication 22) / Class B.
IT power system (For Norway only)
This product is also designed for an IT power system with phase-to-phase
voltage 230V.
Caution for LAN connection
Connect this product to a LAN connection that is not subjected to over
voltages.
8
770 - 800 nm
Class IIIb
(Accordance with 21 CFR Part 1040.10)
Wiring information (for UK)
Important
If you need to replace the plug fuse, fit a fuse that is approved by ASTA to
BS1362 with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug that does not have a cover.
Warning - This printer must be earthed.
The wires in the mains lead are coloured in line with the following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
If in any doubt, call a qualified electrician.