Handle Grip - Stihl Cutquik TS 460 Service Manual

STIHL TS 460
Top: Removing the
mounting screw
Bottom:
Annular buffer
- Unscrew mounting screw
of annular buffer.
- Remove handle tube bracket.
Note: Follow the same procedure
in removing the handle tube
bracket on the other side.
- Press annular buffer out of
handle tube bracket.
The parts are assembled in
reverse order.
Top:
1 =Annular groove
2 = Annular rib
Bottom:
1 = Pressure plate
2 = Mounting screw
Note: Press in annular buffers
until annular groove engages
annular rib on handle tube bracket.
Insert pressure plates in annular
buffer. Screw in screw and tighten
to 8.0 Nm.
9.7 Handle Bar
Top:
1 = Short circuit wire
2 = Ground wire
3 = Throttle cable
Bottom:
AV-molding
mounting screws
- Remove contact springs, see 9.3.
- Pull short circuit and ground
wires and throttle cable out of

handle grip.

- Unscrew mounting screws for
AV-molding, remove AV-molding.
59