Shroud/Housing Parts; Handle Housing - Stihl BT 45 Manual

5.

Shroud/Housing Parts

5.1

Handle Housing

1
– Remove the air filter - b 8.1
: Unscrew the nuts (1) and pull the
manifold with flange off the
carburetor.
– Remove the fan housing with
rewind starter - b 6.1
: Take out the screws (arrows).
12
1
: Take the handle hose (1) out of
the guides (arrows) and pull it off
the handle housing.
– Remove the right-hand handle
housing.
1 2
– Lift the left-hand handle housing
and swing it just a little to one
side.
: Pull the fuel fuel hoses (1) off the
carburetor connectors.
: Disconnect the throttle cable (2)
from the slotted pin on the throttle
lever and pull it out of the spacer
flange (arrow). Do not kink the
throttle cable during this
operation.
– Remove the left-hand handle
housing.
Install in the reverse sequence.
1
– When reinstalling, first remove
the rubber buffers (1) from the
engine and fit them in the left-
hand and right-hand handle
housings.
1
BT 45