Macintosh; For Usb Interface Users (For Mac Os ® X 10.2.4 Or Greater) - Brother MFC-440CN Quick Setup Manual

Installing the Driver & Software
For USB Interface Users
(For Mac OS
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on pages 4 through 13.
Note
®
For Mac OS X 10.2.0 to 10.2.3 users, upgrade to
®
Mac OS X 10.2.4 or greater. (For the latest
information for Mac OS
http://solutions.brother.com)
1
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
2
Connect the USB cable to the USB socket
marked with a
USB socket inside the machine on the right as
shown below.
®
X 10.2.4 or greater)
®
X, visit
symbol. You will find the
3
Carefully guide the USB cable into the trench
as shown below, following the trench aound
and toward the back of the machine. Then,
connect the cable to your computer.
Improper Setup
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your computer.
• Make sure that the cable does not restrict the
cover from closing, or an error may occur.
4
Lift the scanner cover to release the lock (
Gently push the scanner cover support down
( ) and close the scanner cover (
Note
Make sure that the machine is turned on by
connecting the power cord.
5
Turn on your Macintosh
6
Put the supplied CD-ROM into your CD-ROM
drive.

Macintosh

).
).
®
.
23
®