Samsung RT53 Service Manual page 42

1 0
304 views
 
Total Ver.02
Uploaded by epalarcon9
Full description
ninguno
   
Save Embed Share Print
TROUBLESHOOTING
● When the Display Panel converts to the Option Setting mode, the Display will be changed to the Option
Select Mode or the Option Set
1) For example, if you want to shift the standard temp of th e Fridge compartment by -2℃, follow the steps
below. This function is to change the default temperature and when the default temperature of the Fridge
compartment is 2℃ and the default setting is lowered by -2℃ with the Option function, the default
temperature will be controlled at 0℃. That is, wh en changing temperature options, the Fridge compartme
will operate at 0℃ internally even if it shows 2℃ on the display panel. Therefore, the temperature will be
controlled by -2℃ lower than the set temperature on the display panel.
Note
Basically, when units being shipped out, all the data in the Option function are cleared. That is, the Default
settings are "0". However, for the purpose of quality improvement during mass production, the Default
values may change. Therefore, be sure to check quality information, such as SVC bulletins.
2) After changing into the Option mode, "0"s on both of the Fridge and Freezer compartments lights up on
the display panel. (when units being shipped out, the unit will be shipped out with "0" set on the Fridge
compartments. However, for the purpose of quality improvement during mass production, the Default
values may change.)
3) Press the Power Cool button. And, when the LED LAMP (
are on (Setting the Option #), press the Fridge Button and select the LED LAMP which equals to the Set-
Value #4 (
RELATED TITLES
Hotpoint,Mba
4033 Cv
OPTION # SELECT MODE
(Power Cool LED Lamp On)
OPTION # : "0"
OFF, "3℃" LED ON). Then, its default temperature drops by -2℃.
LG_MULTI_F_3828A20097W_1[1] Samsung
Refrigerador
OPTION SET-VALUE SELECT MODE
(Power Cool LED Lamp Off)
OPTION SET-VALUE : "0"
LED On) for the Option #1 and the 7℃ LED

34648123
WD856UH