Tetra LED Waterfall Globe Quick Setup Manual

Start Here - LED W
1
Part Identification
Filter Assembly
Filter
Filter
Cartridge
Holder
Pump with
Impeller
Filter
Housing
Pump Cover
Glass Globe
AC Low Voltage
Adapter Plug
4
Filter Placement
A.
Remove the Filter
Cartridge from package and
insert into Filter Housing.
Note: Replace Filter Cartridge
every 3 to 4 weeks for optimal
fish health.
B. Replace Glass Globe. B
For questions or concerns contact Customer Support 800.526.0650 • www.tetra-fish.com
® Registered Trademark of United Pet Group, Inc. or one of its subsidiaries.
G Quick Setup Guide
aterfall lobe
2
Remove Glass Globe and Bubble Wrap
A. Rotate the LED light up to access
LED Light
the Filter Assembly and Glass Globe.
B.
Assembly from Glass Globe,
then remove Glass Globe
Arm
from Base and set aside.
D. Make sure Pump and Pump Cover
are firmly attached to Filter Housing.
Base
A
C
C. Snap Filter Holder
with Filter Housing
and Pump on lip of
Glass Globe under
LED Light.
A
Carefully remove Filter
B
C. Unwrap Filter Assembly
C
and discard bubble wrap.
D
5
Turn Waterfall and Light On & Off
(I)Symbol ON - (O) symbol OFF
Waterfall
NOTE: To turn waterfall
OFF unplug AC Adapter.
NEVER run the Pump
without water in Globe.
3
Fill Glass Globe
A. Rinse and fill Glass with gravel and decor.
B. Add 75ºF/24ºC dechlorinated tap water
approximately 1´´/2.5 cm from the top edge.
1´´
2.5 cm
C
Light Switch
A. Attach AC Adapter Plug into the
Jack on the back of Waterfall Globe.
B. Plug AC Adapter into power outlet.
This powers LED Lights and Waterfall
Pump. Make a Drip Loop for safety.
C. Rotate the LED light down over the
water. Use Light Switch to power lights
ON and OFF.
A
AC Adapter Plug
75ºF 24ºC
B
ALWAYS:
Make a Drip
Loop
(for safety).
12/11 REV. A 29276-901