Brother DCP-7010 User Manual page 34

Chapter 6
ERROR MESSAGES
ERROR MESSAGE CAUSE
The inside of the machine is too hot.
Machine too Hot
The toner cartridge is not installed
No cartridge
properly.
The machine is out of paper or paper is
No Paper Fed
not properly loaded in the paper tray.
The machine's memory is full.
Out of Memory
Paper jam Inside The paper is jammed inside the
machine.
The paper is jammed in the back of the
Paper Jam Rear
machine.
The paper is jammed in the paper tray
Paper Jam Tray
of the machine.
The scanner glass's sensor
Scanner Locked
does not move to the home position.
The toner cartridge and drum unit
Toner Life End
assembly are not installed or it is not
installed properly.
—OR—
Toner is used up and printing is not
possible.
The toner cartridge is near the end of its
Toner Low
life and will soon need replacing.
The machine has a mechanical
Unable to Init.
problem.
(Initialize)
Unable to Print
Unable to Scan
6 - 2
ACTION
Listen to the machine to check that the cooling fan is
spinning. Make sure that the air vents are not covered
up or blocked.
If the fan is spinning and air vents are clear, you should
let the machine cool down for several minutes before
using it again.
If the fan is not spinning, turn off the machine and then
on again.
Reinstall the toner cartridge.
Refill the paper in the paper tray and then press Start.
—OR—
Remove the paper and load it again and then press
Start.
(Copy operation in process)
Press Stop/Exit and wait until the other operations in
process finish and then try again.
(Printing operation in process)
Reduce print resolution. (See Advanced tab in the
Software User's Guide on the CD-ROM.)
(See Paper jams on page 6-4.)
(See Paper jams on page 6-4.)
(See Paper jams on page 6-4.)
Turn off the machine and then on again.
Re-install the toner cartridge and drum unit assembly.
—OR—
Replace the toner cartridge with a new one.
(See Replacing the toner cartridge (TN-2000) on page
6-20.)
Order a new toner cartridge now.
Turn off the machine's power switch, and then on
again, If the error message continues, leave the
machine for several minutes, and then try to print, copy
or scan again.