Brother DCP-385C Quick Setup Manual

Unpack the machine and check the components
1
Start Here
Important
DO NOT
connect the
USB cable yet.
a.
Warnings tell you what to do to
WARNING
prevent possible personal injury.
e.
Gently put the paper into the paper tray.
Check that the paper is flat in the tray.
Note
When you use Legal size paper, press and hold the
universal guide release button
front of the paper tray.
Important
Do not push the paper
in too far.
d.
Fan the stack of paper well.
d.
Unpack the ink cartridge.
Turn the green knob on the protective yellow cap clockwise until it clicks to release the
vacuum seal, then remove the cap a.
1
Set the LCD contrast (If needed)
Set the language (If needed)
6 7
a.
Press Menu.
b.
Press a or b to choose Initial Setup.
Press OK.
c.
Press a or b to choose Local Language.
Press OK.
d.
Press a or b to choose your language.
Press OK.
e.
Press Stop/Exit.
Before you can use the machine, read this Quick Setup Guide
for the correct setup and installation.
LX0142001
USA/CAN
Printed in China
Note
b.
Remove the green protective packing
• The components of your box may differ
by lifting the front of the machine and then
depending on your country.
pulling down on the packing part.
• Save all packing materials and the box in case
for any reason you must ship your machine.
• A USB cable is not included.
You need to purchase a USB 2.0 cable that is no
more than 6 feet (2 meters) long.
Your machine has a USB 2.0 Full-speed interface.
This interface is compatible with USB 2.0 Hi-Speed;
however, the maximum data transfer rate will be
12 Mbits/s. The machine can also be connected to
a computer that has a USB 1.1 interface.
c.
Remove the plastic bag
Remove the protective tape and film.
ink cartridges from on top of the paper tray.
f.
Gently adjust the paper side guides to the paper with both hands.
Make sure the paper side guides touch the edges of the paper.
g.
Close the paper tray
cover and slowly push
a
as you slide out the
the paper tray back into
the machine.
1
e.
Install each ink cartridge in the direction of the arrow
on the label.
Take care to match the color of the lever
cartridge color b.
a. e.
Press Menu. Press d or c to choose Light, Med or Dark.
Press OK.
b.
Press a or b to choose
f.
Press Stop/Exit.
General Setup.
Press OK.
Note
c. You can also adjust the angle of the display by
Press a or b to choose
lifting it.
LCD Settings.
Press OK.
d.
Press a or b to choose
LCD Contrast.
d.
a
Make sure you have all components.
Starter Ink
2 Cartridges [x4]
Black
Yellow
Cyan
Magenta
Accessory
CD-ROM
Order Form
Quick Setup
User's Guide
Guide
1 1
WARNING
Plastic bags are used in the packaging of your
b containing the
machine. To avoid danger of suffocation, please
keep these bags away from babies and children.
Connect the power cord
3
a.
Connect the power cord.
h.
Pull out the paper
support a until it clicks,
and then unfold the
paper support flap b.
2
1
f.
Gently push the ink cartridge until it clicks. After all the
ink cartridges are installed close the ink cartridge cover.
a with the
1 1
2
Note
The machine will prepare the ink tube system for printing.
This process will take approximately four minutes.
Do not turn off the machine.
Set the date and time
8
a.
Press Menu.
b.
Press a or b to choose
Initial Setup, and then
press OK.
c.
Press a or b to choose
Date&Time, and then press OK.

Quick Setup Guide

Load plain Letter/A4 paper
2
a. c.
Pull out the paper tray. Press and slide the
paper side guides
b.
Lift the paper tray cover a. a and paper length
b
guide to fit the
paper size.
1
Make sure that the
triangular marks
on the paper side
a
guides and paper
length guide
up with the mark for
the paper size you
are using.
Install the ink cartridges
4
a.
The LCD shows:
No Cartridge
Important Install Ink
Black
DO NOT connect the
USB cable yet.
b.
Open the ink cartridge cover a.
Note
The control panel
warning LED will stay on
until you have installed
the ink cartridges.
Check the print quality
5
a. b.
When the preparation process Check the quality of the four color
a
has finished, the LCD shows blocks
this message. (black/yellow/cyan/magenta)
Set Paper and Press
Start
Press Color Start.
o If all lines are clear and visible, press
(Yes) to finish the quality check.
o If you can see missing short lines, press
(No) and follow the steps on the LCD.
d. e.
Press a or b repeatedly to enter the last Repeat for Month and Day, and Hours and
two digits of the year, and then press OK. Minutes in 24-hour format.
Date&Time
Year:20
f.
Press Stop/Exit.
08
Note
MENU Input & Press OK If you make a mistake and want to start
again, press Stop/Exit to go back to step a.
(e.g. Enter 08 for 2008.)
DCP-385C
1
3
c
2
b line
3
c.
Remove the green protective
part a.
1
1
on the sheet.
1
OK
Poor
Turn the sheet over.