Stealth Cam STC-I540IR User Manual page 28

All manuals and user guides at all-guides.com
Using the Camera in PIR Detection Mode
Mount the camera to a tree or other sturdy object using either
•
the supplied mounting strap. (Please refer to the mounting
suggestions section in this manual)
Open the front housing and slide the Toggle switch from OFF
•
to TEST position. You will hear two short consecutive beeps
followed by a third beep.
Move the switch from Test to ON position to activate your PIR
•
mode.
The camera's green LED light will begin blinking and enter
•
count down mode. This is your indication to leave the coverage
area within one minute.
After one minute, the camera will take between 1~9 pictures, or
•
AVI video clip based on your program settings. The camera will
then time out between 1~60 minutes also based on your
selection.
The time between motion detection and the camera taking
pictures may vary due to lighting and environment
conditions, program settings and battery power level.
www.stealthcam.net
STC-I540IR
Toll Free 877-269-8490
28