Stealth Cam STC-I540IR User Manual page 27

All manuals and user guides at all-guides.com
Testing the Camera Coverage Area
After mounting the camera, open front housing and slide the
•
power toggle switch to TEST.
Close the front housing.
•
Walk around in the front of the camera to see if you have
•
mounted the camera in the proper position. A green indicator
light on the front will blink when you have intruded the
coverage area.
Adjust the camera position as needed, and repeat testing until
•
the desired coverage area is achieved.
When you have completed testing the coverage area, open the
•
front housing and slide the power toggle switch from TEST to
ON position. This will exit the test mode. The camera will then
enter one minute count down mode. The front green LED
indicator will blink giving you one minute to leave the coverage
area. Then the camera will enter PIR detection mode.
www.stealthcam.net
STC-I540IR
Toll Free 877-269-8490
27