Table of Contents
Advertisement
L (Battery Low)
When the above message appears immedeately after turning on the A5 GUITAR (or when "F" appears in the display upon every start -
up), the battery for internal memory backup needs to be replaced.
Contact the KORG distributor nearest you or your local KORG dealer or service center and have a qualified technician replace it.
If a problem occurs during normal operation of the A5 GUITAR, follow the suggestions below and check the
A5 GUITAR to spot and remedy the trouble. If the A5 GUITAR still does not function properiy, consult the
KORG distributor nearest you or your local KORG dealer.
Trouble
Counter-measure
1 Check if the Input volume or the Output volume is set to 0. Adjust the level until the input signal reaches the peak
indicator or raise the output volume until sound can be monitored with headphones.
2 It is possible that the level parameter in one of the effects may be set to 0. In such a case
No sound
sound can be heard only when pressing the BYPASS key. Enter the Edit mode and adjust
the appropriate Level parameters.
3 Check if the master volume in the Utility mode is set to 0. If so, reset it to a suitable level.
4 If a volume pedal is connected, it may be in the up or no sound position.
1 Check the Mode LEDs to ensure that the Edit mode is selected.
2 Check the Bank/Effect selector to ensure that the desired effect is properly selected.
3 Check if Bypass has been turned on. When the Mode LEDs are blinking, the A5 GUITAR is in Bypass condition.
No effect No change in
Press the Bypass key to turn it off.
effect when editing
4 Check It the Mix LEVEL parameter in one of the effects is set to 0. If so, reset it to a suitable level.
5 Check If any effects have been set to OFF. Make sure the EFCT/PROG LEDs are lit for the effects you wish to edit.
1 Check if you have attempted to write to the User area. A program can be stored only to the five programs 1 - 5 in
Write operation is
Bank 1.
2 After the write operation is executed, the A5 GUITAR continues to display the source bank and program number,
attempted but not
not the destination bank and program number. If you wish to hear the destination program, use the Bank/Effect
executed
selector to select Bank 1 and select the program.
See
www.hgroenewegen.tmfweb.nl
ERROR MESSAGES
TROUBLESHOOTING
for more
20 sept. 2003
13
Pg
Advertisement
Table of Contents
