Boost Function; Battery Capacity Indication; Usb Charge Function - BAFANG E-SYSTEM Manual

2.6.6 BOOST Function

In riding, when speed is arrived 25km/h, can
select in BOOST level, at this point press
button and hold (>2S), then the Pedelec
enters in BOOST function. The indicator
on display will flash and the motor output
with max. power. (BOOST function as
following). If release the button or do any
other operation will stop BOOST.
NOTE: If the speed is not arrived 25km/h,
this function can not be implemented and
press button and hold (>2S) the HMI can
powered off.

2.6.7 Battery Capacity Indication

The percentage of current battery capacity
and total capacity is displayed from 100%
to 0% according to the actual capacity (as
shown in the figure below)

2.6.8 USB Charge Function

When the HMI is off, insert the USB device
to the USB charging port on the HMI, and
then turn on HMI to charge. When the HMI
is on, can direct charge for USB device. the
maximum charging voltage is 5V and the
maximum charging current is 500mA.
27