Mr. Coffee BVMC-O-C Series Instruction Book page 6

HOW TO MAKE YOUR FIRST
SHOT(S) OF ESPRESSO
1. Fill the water tank to the "MAX" marking with clean, filtered water.
2. Turn the coffeemaker ON by using the power switch on the side.
NOTE: The ready indicator light will pulse while the coffeemaker heats up
and will turn solid when the coffeemaker is ready to use.
3. Select the filter size: 1-shot filter or 2-shot filter. Make sure the bump on
the filter is aligned with the notch on the espresso portafilter and place
the filter into the espresso portafilter.
4. Add espresso grounds into the filter.
1-SHOT
5. Using the tamper, evenly tamp (press) espresso grounds. Then, wipe the
edges to clear any excess grinds.
6. If using a small cup, lower the height adjustment tray. If using a larger
cup, leave the height adjustment tray in the upright position.
7. Insert the espresso portafilter into the coffeemaker:
a. Keep the espresso portafilter handle flat.
b. Insert the espresso portafilter at a 45° angle (left).
c. Turn the espresso portafilter handle to a 90° angle. The espresso
portafilter should be in a centered position.
TURN
a. b.
8. Place the cup underneath the espresso portafilter.
9. Turn the knob to the "brew" position.
10. Use the brew size selector to select 1 shot or 2 shots.
11. Press the brew now button.
12. When the coffeemaker beeps and the brew now indicator light turns off,
turn the knob to the "standby" position.
TURN
13. Enjoy!
9.
BVMC-O-C_19ESM1.indd 9-10
2-SHOT
c.
HOW TO MAKE YOUR FIRST
SINGLE SERVE COFFEE
1. Fill the water tank to the "MAX" marking with clean, filtered water.
2. Turn the coffeemaker ON by using the power switch on the side.
NOTE: The ready indicator light will pulse while the coffeemaker heats up
and will turn solid when the coffeemaker is ready to use.
3. Insert a K-Cup® Pod or permanent single serve filter inside the single
serve portafilter and press it down firmly. Then, place the single serve
portafilter lid over the K-CUP® Pod or permanent single serve filter and
insert it into the coffeemaker.
NOTE: If using the permanent single serve filter, fill the basket with
coffee up to the edge where the nylon mesh ends (about 10 grams of
coffee). Do not over fill.
NOTE: The single serve portafilter lid does not lay flat when a K-Cup®
Pod is inserted.
4. If using a small cup, lower the height adjustment tray. If using a larger
cup, leave the height adjustment tray in the upright position.
5. Insert the single serve portafilter into the coffeemaker:
a. Keep the single serve portafilter handle flat.
b. Insert the single serve portafilter at a 45° angle (left), ensuring the lid
closes during insertion.
c. Turn the single serve portafilter to a 90° angle. The single serve
portafilter should be in a centered position.
TURN
a.
6. Place the cup underneath the single serve portafilter.
7. Turn the knob to the "brew" position.
8. Use the brew size selector to select the desired brew size.
9. Press the brew now button.
10. When the coffeemaker beeps and the brew now indicator light turns off,
turn the knob to the "standby" position.
11. Enjoy!
NOTE: After brewing, remove the single serve portafilter from the
coffeemaker carefully and dump any remaining water into the sink before
lifting the lid.
TURN
b. c.
10.
5/24/19 09:16