Advertisement
FCC (Federal Communications Commission)
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference;
2. This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B dig-
ital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
●
Consult the dealer or an experienced radio/TV technician for help.
FDA (Food and Drug Administration)
This device complies with IEC/EN 60825-1:2014, 21 CFR 1040.10 and 1040.11 except for
conformance with IEC 60825-1 Ed. 3, as described in Laser Notice No. 56, dated May 8,
2019. It is subject to the following conditions:
●
Class 1 laser product
●
LASER RADIATION for laser module
●
655 nm, CW (continuous wave), for laser leakage < class 1 laser product limit (0.39 mW)
NOTE: The sensor module of fine dust duct sensor is fully enclosed, so no potentially haz-
ardous radiation is accessible during use. In order to avoid inadvertent exposure to hazard-
ous laser radiation, do not disassemble the housing of sensor module during operation or
maintenance. If the housing is broken, do not use and replace with a new module.
Open Source Software (OSS)
All open source software components used within the product (including their copyright hold-
ers and the license conditions) can be found from the website
http://www.siemens.com/download?A6V11998673.
12
Siemens
Smart Infrastructure
A6V11893002_en--_c
2021-07-05
Advertisement
