Synthesizer Troubleshooting; 19.44 Mhz Reference Oscillator - Nokia NKC-1X Series Troubleshooting Instructions

CCS Technical Documentation
Note: TXPWRDET is the difference between TX on burst and off burst.
2500
2000
1500
1000
500
0
2

Synthesizer Troubleshooting

There are four oscillators generating the needed frequencies for RF-section. 19.44 MHz
VCTCXO is used as a refence signal oscillatorreference oscillator, 2GHz UHF VCO with
loop filter circuit is used for RX and TX channel selection, TX VHF and RF VHF are for TX
modulator and 2nd RX mixer locals generation.
The VHF synthesizers are integrated in TACO, but have external VCO coils and loop filters.
RX VHF frequency is fixed 271.08 MHz and TX VHF is fixed to 271.08 MHz . All locals are
locked to stable 19.44MHz reference oscillator.
The frequency range for 2GHz UHF VCO is: 2009.1 ... 2125.53 MHz. The output frequency
range for the lower band is from 2009.16 to 2059.02MHz. In upper band the output fre-
quency range from the UHF VCO is from 2031.78MHz to 2125.53MHz.
It is practical way to check out synthesizer status by measuring control voltage of the
VCO from Integrator capacitor. If voltage is stable and reasonable, local oscillators are
running correctly.

19.44 MHz reference oscillator

The VCTCXO oscillator frequency (G790) is controlled by UEM. This output 19.44 MHz
signal is connected to TACO. It is used as a reference signal in TACO and also fed out as
buffered clock signal to UPP. All synthesizers use divided 19.44 MHz signal as a reference
Issue 1 02/03
Figure 14: Detected voltage limits
3 4 5
Power Level
Nokia Corporation
Troubleshooting Instructions
6 7 8
NKC-1X
A800
D800
9 1
Page 29