Table of Contents
Advertisement
6.GENERAL OPERATION
1) POWER BUTTON
Press power button to turn on/off the unit.
4) MENU BUTTON
You can operate the following function through MENU button.
A. AUDIO OPERATION
press MENU button for less than 1 second to open the Audio menu.
press MENU repeatedly to navigate through the following functions:
VOLUME (VOL) -> BASS (BAS) -> TREBLE (TRE) -> BALANCE (BAL) -> FADER (FAD)
Rotate Volume Control to adjust desired level within 5 seconds.
NOTE: BASS AND TREBLE WILL BE SKIPPED IF DSP MODE IS ACTIVATED
B. OTHER OPERATION
press MENU button for more than 2 seconds to open another set of menu, press MENU
button repeatedly to navigate through the menu items, while the desired menu item is
displayed, use Volume control to adjust the selected function:
- TA ALARM
To determine what action will the radio take if the newly tuned station does not receive TP
information for 5 seconds.
TA SEEK
The radio retunes to a different station which contains TP information.
TA ALARM
The radio does not retune but beeps will come out.
- MASK PI, MASK ALL
"PI" is referred to "Different PI with same AF".
During AF search, PI stations and non-RDS stations with strong signal will be masked, in the
latter case, the non-RDS stations may cause interference, resulting the real AF to be masked
due to the misjudgment of the radio under interference.
There are two options to handle this situation.
MASK PI to mask only the AF with different PI.
MASK ALL mask both PI and strong signal non-RDS stations.
- RETUNE L, RETUNE S
To determine the initial time of automatic TA search.
RETUNE L 180 seconds
RETUNE S 45 seconds
- LOUD MODE
Use this mode to increase bass output.
- ESP MODE (ELECTRONIC ANTI-SKIP PROTECTION)
You can select the second of ESP as follow
ESP 12 second: For normal road condition
ESP 45 second: For road conditon extremely UN-EVEN.
- BEEP MODE (BEEP ON / OFF)
BEEP OFF: disable audible beep tone when any function is accessed.
BEEP ON: enable audible beep tone.
- SEEK MODE (SEEK 1 / SEEK 2)
You can choose from Seek tuning mode 1 & mode 2 by using Volume Control.
While the desired Seek tuning mode is selected, the following operations can be performed:
SEEK1: Press the Tuning Up / Down Button briefly to increase or decrease the frequency by 1 step
size.
Press and hold the Tuning Up / Down button to seek the band in up or down direction
and stop when a station is received.
SEEK2: Press the Tuning Up / Down Button briefly to increase or decrease the frequency by 1 Step
size.
Press and hold the Tuning Up / Down button increase or decrease the frequency rapidly
until the button is released, the different between the same operation at SEEK 1 mode is
that this time the radio will not stop at any station.
E - 8
Advertisement
Table of Contents
