Table of Contents
Advertisement
GETTING STARTED
Battery Removal and Installation
1. Make sure the toy is turned OFF.
2. Locate the battery cover on
the back of the play set. Use a
screwdriver to loosen the screw.
Then, remove the cover.
3. If used or spent batteries are
present, remove these batteries
from the toy by pulling up on one
end of each battery.
4. Install 2 new AA size (LR6/AM-3)
batteries following the diagram
inside the battery box. (The
use of new alkaline batteries
is recommended for maximum
performance).
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
•
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
•
Only batteries of the same or equivalent type as recommended
are to be used.
•
Do not short-circuit the supply terminals.
9
Advertisement
Table of Contents
