Headband Cushion; Removing Environmental Moisture; Replacing Parts; Microphone Windscreen Replacement - Bose Aviation Headset X Owner's Manual

Replacing parts

Headset Care and Maintenance

Headband cushion

1. Remove the cushion as described below.
2. Place the cushion in a solution of water and a mild detergent
such as Woolite.
3. Allow the cushion to air dry. Then, reattach by following the
instructions below.

Removing environmental moisture

If the protective inner screen becomes damp, due to environmental
moisture such as light rain, dew, perspiration, or condensation, allow
it to air dry only. Do not use electric heaters, blowers, or hairdryer
type devices to dry the inner screen.
If the headset is immersed in liquid, do not use it. Contact the Bose
Aviation Headset Department for assistance.
Through normal use, parts like windscreens and ear cushions may
require periodic replacement.

Microphone windscreen replacement

1. Remove the band that secures the windscreen by rolling the
band from the tip of the microphone.
2. Gently pull the windscreen off of the microphone.
3. Slide-on the replacement windscreen and make sure that it fits
completely over the microphone.
4. Roll a new band to the proper position, about
end of the windscreen, to secure it.

Ear cushion replacement

1. Grasp the ear cushion skirt where it folds into the slot on the ear-
cup (Figure 21 on page 28).
2. Gently pull the ear cushion skirt up and away from the earcup.
3. Properly position the replacement ear cushion against the ear-
cup.
AM270261_00 V.pdf May 16 2003
®
1 / inch from the
4
27